Altronix eFlow104NKA8D Networkable Dual Output Power Supply/Charger

Technical Specification

Features:
  • Make: Altronix
  • Model code: eFlow104NKA8D
  • Input Voltage: 120 V AC
  • Output Voltage: 24 V DC
  • Power Supplies & Batteries: Yes
Additional info:

Altronix eFlow104NKA8D converts a 120VAC 60Hz input into eight (8) PTC protected powerlimited outputs. Outputs are individually selectable, providing providing 12VDC or 5VDC up to 6A and/or 24VDC up to 10A (240W total power) for access control panels, door locks, and ancillary devices. Power outputs can be converted to dry form “C” contacts. Outputs are activated by an open collector sink, normally open (NO), normally closed (NC) dry trigger input, or wet output from an Access Control System, Card Reader, Keypad, Push Button, PIR, etc. eFlow104NKA8D will route power to a variety of access control hardware devices including Mag Locks, Electric Strikes, Magnetic Door Holders, etc. Outputs will operate in both Fail-Safe and/or Fail-Secure modes. The FACP Interface enables Emergency Egress, Alarm Monitoring, or may be used to trigger other auxiliary devices. The fire alarm disconnect feature is individually selectable for any or all of the eight (8) outputs. The spade connectors allow you to daisy chain power to multiple ACMS8CB modules. This feature allows you to distribute the power over more outputs for larger systems.

Read more
Make Altronix
Manufacturer Altronix
Model code eFlow104NKA8D
Input Voltage 120 V AC
Output Voltage 24 V DC
Power Supplies & Batteries Yes
Environmental Specifications Operating Temperature C: 0 ~ 49 C (32 ~ 120 F )
Operating Humidity %: 85
Physical Specifications Dimension mm: 305 x 394 x 114
Weight g: 4260
Additional info

Altronix eFlow104NKA8D converts a 120VAC 60Hz input into eight (8) PTC protected powerlimited outputs. Outputs are individually selectable, providing providing 12VDC or 5VDC up to 6A and/or 24VDC up to 10A (240W total power) for access control panels, door locks, and ancillary devices. Power outputs can be converted to dry form “C” contacts. Outputs are activated by an open collector sink, normally open (NO), normally closed (NC) dry trigger input, or wet output from an Access Control System, Card Reader, Keypad, Push Button, PIR, etc. eFlow104NKA8D will route power to a variety of access control hardware devices including Mag Locks, Electric Strikes, Magnetic Door Holders, etc. Outputs will operate in both Fail-Safe and/or Fail-Secure modes. The FACP Interface enables Emergency Egress, Alarm Monitoring, or may be used to trigger other auxiliary devices. The fire alarm disconnect feature is individually selectable for any or all of the eight (8) outputs. The spade connectors allow you to daisy chain power to multiple ACMS8CB modules. This feature allows you to distribute the power over more outputs for larger systems.

Download PDF version Download PDF version