The Altitude 9540 IP camera utilizes IGMP Snooping (Layer-2 multicasting) technology, which enables a single stream to be transmitted to multiple viewers on the network simultaneously. Multicasting reduces bandwidth demands, allowing cameras to be transmitted over the network than unicast based products including unicast IP cameras and DVRs.
| Make | FLIR Systems |
|---|---|
| Manufacturer | FLIR Systems |
| Previously known as | DVTEL |
| Model code | DVT - 9540SW |
| Chip Inch Size | 1/3 inch |
| Colour Type | Colour |
| Resolution | 704 x 576 resolution |
| Digital (DSP) | Yes |
| Sensitivity Lux | 0.8 |
| Auto Iris | Yes |
| Direct Drive | Yes |
| Lens Mount | C/CS mount |
| Electrical Specifications |
Voltage: 12 V DC Power Consumption: 8 W |
| Focal Length mm | 2.6 ~ 6 |
| Wide Dynamic Range | Yes |
| Network Properties |
Image Frame Rate: 25 / 30 fps Interface: 10/100 Base-T Network Protocols: RTP/IP,UDP/IP,TCP/IP,DNS,DHCP |
| Back Light Compensation | Yes |
| Auto Gain Control | Yes |
| White Balance | Yes |
| S/ N (Signal/ Noise) Ratio dB | 42 |
| Signal Mode | PAL/NTSC |
| Compression Type | MPEG-4 |
| Additional info |
The Altitude 9540 IP camera utilizes IGMP Snooping (Layer-2 multicasting) technology, which enables a single stream to be transmitted to multiple viewers on the network simultaneously. Multicasting reduces bandwidth demands, allowing cameras to be transmitted over the network than unicast based products including unicast IP cameras and DVRs. |