Pelco IMPS110-1I is a day/night indoor IP mini dome camera with remote zoom lens for wide angle or long range surveillance needs. It supports up to two simultaneous video streams and a third service stream as well as features a simple motion detection algorithm that allows the camera to record or send an alarm when there is motion detected in a selected zone or within the entire scene. The camera integrates with major third-party video management systems through the Pelco API and other third-party software and systems through the open ONVIF Profile S standard.
| Make | Pelco |
|---|---|
| Manufacturer | Pelco, Inc |
| Model code | IMPS110-1I |
| Chip Inch Size | 1/4 inch |
| Colour Type | Colour / Monochrome |
| Resolution TVL | 800 x 600 |
| Dome Type | PTZ |
| Sensitivity lux | 0.01 |
| Pan Speed o/ sec | Manual : 355 o/ sec pan speed |
| Digital (DSP) | Yes |
| Tilt Speed o/ sec | Manual : 75 o/ sec tilt speed |
| Indoor/Outdoor | Indoor |
| Mount Type | In-Ceiling mount |
| Electrical Specifications |
Voltage: PoE, 18 ~ 32 V AC Power Consumption: < 6 W |
| Focal length | 2.8 ~ 10 mm |
| Rotation Angleso | 360 |
| Compression | H.264 high or main profiles; and MJPEG |
| White Balance | Yes |
| Electronic Shutter range | 1/5 ~ 1/10,000 sec |
| Network Properties |
Interface: RJ-45 connector for 100Base-TX Network Protocols: TCP/IP, UDP, ICMP, IPv4, SNMP v2c/v3, HTTP, HTTPS, SSL, SSH, SMTP, FTP, RTSP, UPnP, DNS, NTP, RTP, RTCP, LDAP Image Frame Rate: 30 ips Inclusive DVR/ Web Server: MicroSDHC or SDXC card |
| Physical Specifications | Weight g: 610 |
| Environmental Specifications |
Operating Temp oC: -10 ~ +50 C (14 ~ 122 F) Operating Humidity %: 15 ~ 85 |
| System Requirements | Web Browser: Microsoft Internet Explorer 8.0 and later |
| Additional info | Pelco IMPS110-1I is a day/night indoor IP mini dome camera with remote zoom lens for wide angle or long range surveillance needs. It supports up to two simultaneous video streams and a third service stream as well as features a simple motion detection algorithm that allows the camera to record or send an alarm when there is motion detected in a selected zone or within the entire scene. The camera integrates with major third-party video management systems through the Pelco API and other third-party software and systems through the open ONVIF Profile S standard. |