Arecont Vision AV2355RS IP megapixel camera

Technical Specification

Features:

Make: AV Costar
Previously known as: Arecont Vision
Model code: AV2355RS
Series: MegaDome G3 RS Series
Chip Inch Size: 1/3 inch

Additional info:

MegaDome® G3 RS third generation megapixel cameras provide ample resolution to zoom-in for details in live or recorded video. With an IR corrected motorized lens and gimbal, MegaDome G3 RS is easy to install and manage with “no-touch” remote setup. Install the magnetic mounting plate, connect the PoE (Powerover-Ethernet) IP cable, magnetically snap in place and fasten the camera to the mounting plate, and then remotely configure the camera. Use the intuitive interface to remotely pan, tilt, zoom, and focus the sensor.

Contact manufacturer Contact manufacturer Datasheet Datasheet

Make	AV Costar
Manufacturer	AV Costar (Arecont Vision)
Previously known as	Arecont Vision
Category	CCTV>IP Dome cameras
Model code	AV2355RS
Series	MegaDome G3 RS Series
Chip Inch Size	1/3 inch
Colour Type	True Day / Night
Resolution TVL	1080p
Megapixel	Yes
Sensitivity lux	0.02 ~ 0.2
Indoor/Outdoor	Indoor/Outdoor
Digital (DSP)	Yes
Mount Type	Corner, Flush, Pole, Pendant, Wall mount
Electrical Specifications	Voltage: 12 ~ 48 V DC / 24 V AC / PoE Power Consumption: 2.28 W
Focal length	2.8 ~ 6 mm
Compression	H.264
Back Light Compensation	Yes
White Balance	Yes
Electronic Shutter range	1ms–500ms
S/ N (Signal/ Noise) Ratio dB	45
Signal Mode	PAL, NTSC
Network Properties	Interface: 100Base-T Ethernet Network Protocols: RTSP, RTP/TCP, RTP/UDP, HTTP, DHCP, TFTP, HTTPS, 802.1x Image Frame Rate: 30 fps
Physical Specifications	Dimensions mm: 147 x 128 Weight g: 1020
Environmental Specifications	Operating Temp ^oC: -40 ~ +50 C (-40 ~ +122 F) Operating Humidity %: 0 ~ 90
Additional info	MegaDome® G3 RS third generation megapixel cameras provide ample resolution to zoom-in for details in live or recorded video. With an IR corrected motorized lens and gimbal, MegaDome G3 RS is easy to install and manage with “no-touch” remote setup. Install the magnetic mounting plate, connect the PoE (Powerover-Ethernet) IP cable, magnetically snap in place and fasten the camera to the mounting plate, and then remotely configure the camera. Use the intuitive interface to remotely pan, tilt, zoom, and focus the sensor.
Download PDF version Download PDF version