NVT NV-214A-M single channel passive transceiver (coax pigtail & Male BNC)

Technical Specification

Please note: this is a discontinued product.

Go to Replacement product

NVT NV-214A-M single channel passive transceiver (coax pigtail & Male BNC)

Features:

Make: NVT Phybridge
Model code: NV-214A-M
Transmission type: UTP / CAT 5 transmission
Video Inputs: 1 channels
TX/RX: TX/RX

Additional info:

The NVT Model NV-214A-M Video Transceiver is a passive (non-amplified) device that allows the transmission of real-time monochrome or colour video over Unshielded Twisted-Pair (UTP) telephone wire. Baseband (composite) signals of any type are supported. Features a 9 inch mini-coax pigtail w/Male BNC. Built-in transient protection. Supports "up-the-coax" type control signal up to 750 ft. Transmit up to 750 ft, 3000 ft with an active receiver.

Contact manufacturer Contact manufacturer

Datasheet Datasheet

Make	NVT Phybridge
Manufacturer	NVT Phybridge
Category	CCTV>Analogue Transmission
Model code	NV-214A-M
Transmission type	UTP / CAT 5 transmission
Video Inputs	1 channels
TX/RX	TX/RX
Telemetry Control	Yes
Pre & Post Alarm Image Buffer	Yes
Video Outputs	1
Transmission Range m	225
Physical Specifications	Weight g: 60 Dimensions mm: 45 x 26 x 228
Environmental Specifications	Operating Temp ^oC: -30 ~ +75 Operating Humidity %: 0 ~ 95
Additional info	The NVT Model NV-214A-M Video Transceiver is a passive (non-amplified) device that allows the transmission of real-time monochrome or colour video over Unshielded Twisted-Pair (UTP) telephone wire. Baseband (composite) signals of any type are supported. Features a 9 inch mini-coax pigtail w/Male BNC. Built-in transient protection. Supports "up-the-coax" type control signal up to 750 ft. Transmit up to 750 ft, 3000 ft with an active receiver.
Download PDF version Download PDF version